Nilfisk-ALTO SSE 350 User Manual download pdf (Page 9)

9

SSE 350

3 Servicing/Maintenance

3.2 Maintenance schedule

if neededAfter every use weekly

Flush pump system with

clean water

Clean fresh water and dirty

water tank

Clean lower machine section

with a damp cloth

Inspect wiping lips for wear

and clean or replace if

necessary

Replace brush roller

3.1 Important safety notes

CAUTION!

Always disconnect mains plug/

battery connection before working

on machine!

WARNING!

Only carry out maintenance and

repair work described in the

operating instructions.Überlassen

Sie Service- und Reparaturarbeiten,

Always leave servicing and repair

work, especially the elimination of

electrical faults, to the Alto

Customer Service staff or to an

authorised specialist.

Servicing/Maintenance

3.3 Maintenance work

3.3.1 Flushing pump system

• Fill fresh water bag drained of

cleaning agent with approx. 1 l

of clean water.

• Set three-position switch (B) to

position ‘1’. (Fig. 7) Spraying

pump runs. Flush spraying

pump with clean water for

approx. 1 min.

• Catch exiting clean water of

vacuum up with machine.

3.3.2 Cleaning fresh water

and dirty water tank

• Remove tank from automatic

cleaning machine before

cleaning and draining dirty and

fresh water.

Drain dirty water tank:

• Pull of drain plug.

• Pour out dirty water via housing

corner.

Remove fresh water bag:

• Slightly pull up tab of fresh

water bag (Fig. 3/1) and unhook

from edge.

• Lay bag in tank and remove

through large tank opening.

(Fig. 3/2)

• Drain fresh water tank and flush

with fresh water.

• If necessary, hang up bag to dry

and thoroughly flush tank.

Control/Operation

After draining:

• Press drain plug back into

opening. (Fig. 8/4)

• Flush sieve in tank cover with

clean water if dirty. (Fig. )

• Check suction lips on suction

nozzle for dirt deposits (paper,

cigarette residues, sand etc.)

before machine is refilled and

put into operation again.

2.4 After use

• Set ON/OFF switch to ‘OFF’

position. (Fig. 7)

• Set three-position switch to

position 2, ‘OFF’. (Fig. 7)

• Raise suction nozzles. (Fig. 5/3)

• Pull out mains plug.

• Wind up power cable.

• Store machine in frost-free

room.

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments