Nilfisk-ALTO SW 750 User Manual Page 48
- Page / 76
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
ENGLISH
USER MANUAL
10
146 3080 000(1)2006-10 A SW 750
USE
WARNING!
On some points of the machine there are some adhesive plates indicating:
DANGER
WARNING
CAUTION
NOTE
–
–
–
–
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if they are damaged.
BATTERY CHECK ON A NEW MACHINE
The machine is supplied with a standard 12 V, 45 Ah GEL battery (which does not require maintenance).
BEFORE MACHINE START-UP
Make sure that there are no open doors/hoods and that the machine is in normal operating conditions.
If the machine has not been used after being transported, check that all the blocks used for the transportation have been
removed.
Check that side and main broom are installed, otherwise install them (see the procedure in the Maintenance chapter).
STARTING AND STOPPING THE MACHINE
Starting the machine
Adjust the handlebar (6) to reach a comfortable position, by loosening the knobs (7).
When the adjustment is completed, tighten the knobs.
To use the main broom only (14), turn the main switch (1) to “I”.
To use also the side broom (11), turn the main switch (1) to “II”, then lower the side broom by disengaging the lever (12)
and by pushing it forward.
Check that the green warning light (2) (charged battery) turns on.
If the yellow or red warning light (3 or 4) turns on, turn the main switch (1) back to “0” and charge the batteries (see the
procedure in the Maintenance chapter).
NOTE
The side broom (11) can be lifted and lowered even if it is turned on.
Start sweeping by grasping the handlebar (6) and pulling the drive control lever (5) gradually.
Stopping the machine
Release the drive control lever (5) to stop the drive system.
Turn off the vacuum system and the brooms, by turning the main switch (1) to “0”.
Lift the side broom (11) by pulling the lever (12) backwards and by engaging it to the fastener.
1.
2.
3.
1.
2.
3.
1.
2.
3.
- DEUTSCH BETRIEBSANLEITUNG 1
- ENGLISH USER MANUAL 1
- NEDERLANDS GEBRUIKSAANWIJZING 1
- 146 3080 000(1)2006-10 A 1
- INHALTSVERZEICHNIS 3
- EINLEITUNG 4
- AUSPACKEN/AUSLIEFERUNG 5
- SICHERHEIT 6
- MASCHINENBESCHREIBUNG 8
- ZUBEHÖRE/OPTIONEN 10
- TECHNISCHE DATEN 10
- SCHALTPLAN 11
- VOR DEM ANLASSEN DER MASCHINE 12
- NACH DER MASCHINENBENUTZUNG 13
- ERSTE BEDIENUNGSZEIT 13
- MASCHINE IN BETRIEB 13
- PRÜFUNG DES LADEGERÄTKABELS 14
- PRÜFUNG UND EINSTELLUNG DER 15
- SEITENBESENHÖHE 15
- HAUPTKEHRWALZENHÖHE 16
- BETRIEBSANLEITUNG 17
- REINIGUNG UND 18
- VOLLSTÄNDIGKEITSPRÜFUNG DES 18
- DES ABFALLBEHÄLTERS 18
- PRÜFUNG DER FLAPSHÖHE UND 19
- FUNKTIONSFÄHIGKEIT 19
- BATTERIELADUNG 19
- FEHLERSUCHE 20
- VERSCHROTTUNG 20
- TABLE DES MATIERES 21
- INTRODUCTION 22
- DEBALLAGE / LIVRAISON 23
- SECURITE 24
- MANUEL D'UTILISATION 25
- FRANÇAIS 25
- DESCRIPTION DE LA MACHINE 26
- ACCESSOIRES / OPTIONS 28
- CARACTERISTIQUES TECHNIQUES 28
- SCHEMA ELECTRIQUE 29
- UTILISATION 30
- MACHINE AU TRAVAIL 31
- VIDANGE DU CONTENEUR DECHETS 31
- ENTRETIEN 32
- BALAI LATERAL 33
- BALAI CENTRAL 34
- CONTROLE DE LA HAUTEUR ET DU 37
- FONCTIONNEMENT DES VOLETS 37
- CHARGEMENT DES BATTERIES 37
- DEPISTAGE DES PANNES 38
- MISE EN DECHARGE 38
- TABLE OF CONTENTS 39
- UNPACKING/DELIVERY 41
- GENERAL INSTRUCTIONS 42
- USER MANUAL 43
- MACHINE DESCRIPTION 44
- ACCESSORIES/OPTIONS 46
- TECHNICAL DATA 46
- WIRING DIAGRAM 47
- BEFORE MACHINE START-UP 48
- MACHINE OPERATION 49
- HOPPER EMPTYING 49
- AFTER MACHINE USE 49
- MACHINE LONG INACTIVITY 49
- FIRST PERIOD OF USE 49
- MAINTENANCE 50
- SIDE BROOM HEIGHT CHECK AND 51
- ADJUSTMENT 51
- MAIN BROOM HEIGHT CHECK AND 52
- CHECK, HOPPER GASKET CHECK 54
- BATTERY CHARGING 55
- TROUBLESHOOTING 56
- SCRAPPING 56
- INHOUDSOPGAVE 57
- INLEIDING 58
- MODIFICATIES EN VERBETERINGEN 59
- BEDRIJFSCAPACITEIT 59
- ALGEMENE OPMERKINGEN 59
- VEILIGHEID 60
- GEBRUIKSAANWIJZING 61
- NEDERLANDS 61
- BESCHRIJVING VAN DE MACHINE 62
- ACCESSOIRES / OPTIES 64
- TECHNISCHE EIGENSCHAPPEN 64
- ELEKTRISCH SCHEMA 65
- DE MACHINE STARTEN EN STOPPEN 66
- MACHINE IN BEDRIJF 67
- DE AFVALCONTAINER LEGEN 67
- NA GEBRUIK VAN DE MACHINE 67
- LANGE PERIODE VAN STILSTAND 67
- EERSTE GEBRUIKSPERIODE 67
- ONDERHOUD 68
- DE HOOGTE VAN DE ZIJBORSTEL 69
- CONTROLEREN EN AFSTELLEN 69
- DEMONTAGE/MONTAGE VAN DE 71
- HOOFDBORSTEL 71
- VAN DE AFVALCONTAINER 72
- VAN DE FLAPS 73
- ACCU OPLADEN 73
- STORINGEN LOKALISEREN 74
- VERWIJDERING 74
Related products and manuals for Floor Machine Nilfisk-ALTO SW 750
(124 pages)
(76 pages)
(52 pages)© 2020, manymanuals.com. All rights reserved. | 2.632 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals