Nilfisk-ALTO ATTIX 550-2M User Manual download pdf (Page 5)

3

english

ATTIX 360-2M

ATTIX 550-2M / ATTIX 560-2MXC

ATTIX 751-2M / ATTIX 761-2MXC

1)

Option depending on model

Precautions and safety regu-

lations when using the vacu-

um cleaner

Before start-up

Inspect power cord regularly

to detect signs of damage, e.g.

cracks or ageing.

If the power cord is damaged,

it must be replaced by Nilfisk-

Alto-Service or an electrician to

avoid danger before use of the

vacuum cleaner is continued.

Use only the type of power

cord specified in the operating

manual.

Do not damage the power cord

(e.g. by moving over it or pulling

or crushing it).

Disconnect the power cord by

pulling the plug only (do not pull

or tug the power cord).

Inspect the vacuum cleaners to

ensure that they are in proper

condition. Plugs and couplings

in power cords must at least

have splash protection.

Never use the vacuum cleaner if

the filter element is damaged.

Picking up liquids

If foam develops or liquid

emerges, stop work immediately

and empty the dirt tank.

Regularly clean the built in float

(ATTIX 360-2M/550-2M/751-

2M) and level indicator hose

(ATTIX 560-2MXC/761-2MXC)

to limit the water level and check

that they are not damaged.

See section 5 for information on

handling liquids and (hazard-

ous) dust.

Electrical components

Check the rated voltage of the

vacuum cleaner before con-

necting it to the mains supply

system. Ensure that the voltage

shown on the rating plate cor-

responds to the voltage of the

local mains power supply.

If you are using an extension

cord, use only those specified

by the manufacturer or higher

quality ones (see section 9.4

„Technical data“).

It is recommended that the

vacuum cleaner should be con-

nected via a residual current

circuit breaker. This stops the

supply of electricity if the leak-

age current to earth exceeds 30

mA for 30 ms or it has an earth

tester circuit.

When using an extension lead,

check the minimum cross-sec-

tions of the cable:

Cable length

m

Cross section

<16 A <25 A

up to 20 m

ø1.5mm² ø2.5mm²

20 to 50 m

ø2.5mm² ø4.0mm²

Arrange the electrical parts

(sockets, plugs and couplings)

and lay down the extension lead

so that the protection class is

maintained.

Never spray water on to the

upper section of the vacuum

cleaner. Danger for persons,

risk or short-circuiting.

Observe the latest edition of the

IEC regulations.

1 2 3 4 5 6 7 8 9 10 ... 17 18

Comments to this Manuals

No comments