Nilfisk-ALTO CR 1500 User Manual download pdf (Page 29)

GENERAL MACHINE MAINTENANCE

ENGINE

Read and follow all the instructions in the Engine Manual Section. Due to the nature of work being done by the machine, extra care must be taken

to protect the engine from these elements. Check the oil each day before starting operations. Be sure to check the air ﬁ lter cap’s dust collector and

empty as necessary. Also check the air cleaner and replace as conditions demand. Do not let the engine become coated with dust and dirt.

FIGURE 24

TO REMOVE MAIN SWEEPING BROOM

1. Open the Right Broom Chamber Door (A).

2. Put the main broom control in the “SWEEP” position.

3. Remove the Retaining Bolt (B).

4. Remove the Idler Arm Assembly (C).

5. Remove the Main Broom (D) and discard.

6. Put a new main broom in the broom chamber.

7. Rotate the new broom to the right on the Drive Hub (E) until it engages the drive hub broom tabs.

8. Put the Idler Arm Assembly (C) in place.

9. Put the Retaining Bolt (B) in place and tighten.

10. Close the Broom Chamber Door (A).

11. Start the engine.

12. Put the broom lever in the “SWEEP” position.

13. Let the broom sweep in place for 30 seconds.

14. Put the broom lever in the “UP” position.

15. Back the machine off the test spot.

16. Inspect the polished area where the broom swept, for broom bristle contact with the ﬂ oor. The area of broom bristle contact with the ﬂ oor

should be 2 to 3 inches (5 to 8 cm.) wide.

ENGLISH / A-29

FORM NO. - 56041719 - CR 1500 - A-29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 75 76

Comments to this Manuals

No comments

Nilfisk-ALTO CR 1500 User Manual Page 29

Comments to this Manuals

Related products and manuals for Floor Machine Nilfisk-ALTO CR 1500